Price range: $ 9.00 through $ 67.50
Minijet Bilge Pump Mounting Plate
$ 30.00 $ 27.00
The Minijet bilge pump mounting plate simplifies the mounting and installation of automatic bilge pumps in all compatible Minijet hulls and stringers. The bracket recesses the bilge pump into the stringer cavity, placing the pump pickup at the lowest possible spot in the bilge. Pump mounting holes and are pre-drilled and ready for suitable rivets.
We also offer this mounting plate as part of a complete bilge-pump kit.
Related products
Minijet Cold Air Intake Kit
- Vibrant classic air filter with SS hose clamp
- Air filter mounting tube
- 3ft of Canaflex semi-rigid air hose
- QTY 2 stainless steel hose clamps
Heat Exchanger
Heat exchanger for closed cooled Seadoo and small car motors. End caps are removable for easy winterizing and for cleaning out debris. Each end cap can be rotated and fastened in multiple orientations at 90 degree intervals to facilitate optimal hose management.
Glycol flows through 2 center fittings (1 inch hose size on Sea-Doo’s)
Lakewater flows through two brass end caps (3/4 inch hose size on Sea-Doo’s)Fittings included are:
2x 3/4 inch NPT to 1 inch barb 2x 3/4 inch NPT to 3/4 inch barb
Rule RM1100B Automatic Bilge Pump
- Capacity: 1,100 GPH
- Volts: 12VDC
- Amperage: 3.8 amp draw at maximum flow
- sold with straight fitting adapters for 1" and 1-1/8" hose.
- sold with snap on strainer that allows for easy cleaning and mounting.
Bilge Hose (1-1/8in diameter, 6ft length)
