Yamaha Engine Mounts
CAD $ 375.00
Designed for mounting 1800cc Yamaha engines. These engine mounts are designed to work with common stringer interfaces on all Minijet A2 series hulls. This mount assembly replaces the OEM cast engine mounting brackets that are attached to the engine block, and they allow you to reuse the OEM straight rubber isolator mounts.
Please note, these motor mounts are provided as a tack-welded kit. They are pre-assembled in the correct orientation to work with most engines. You must confirm this orientation and complete the remaining welding work before installing these mounts.Â
Related products
Rule RM1100B Automatic Bilge Pump
Our go-to fully automatic bilge pump takes the hassle and guesswork out of keeping your boat dry and safe! The Rule RM1100B features a built in water sensor that eliminates the need for a separate float switch and extra wiring. The pump also has built in programming that can turn off the pump when it pump is running but not pumping water to protect the pump, and batteries.
- Capacity: 1,100 GPH
- Volts: 12VDC
- Amperage: 3.8 amp draw at maximum flow
- sold with straight fitting adapters for 1" and 1-1/8" hose.
- sold with snap on strainer that allows for easy cleaning and mounting.
We also offer this in a Bilge Pump Kit with hose, aluminum fitting and Stringer Mounting Plate.
Minijet Electric Trim Actuator Kit
The Minijet Electric Trim Actuator Kit includes a 12v Electric Linear Actuator, 2 control relays, 6ft Trim Cable, Cable End, Cable Extension, Mounting Plate, Cable Travel Arm, Cable Mounts and Installation Hardware.
This kit will still require Momentary Switches which we sell separately.
HD Battery Retainer Strap Pair
Much stronger and slightly shorter than OEM straps which takes away the slack when using aftermarket batteries. 10 inches total length (hook to hook).
These straps can be added to the Minijet Battery Box incase your donor PWC does not have OEM straps to use.
(Battery Box sold separately).
