Additional information
| Weight | 2.25 kg |
|---|---|
| Dimensions | 25 × 15 × 10 cm |
Yamaha Engine Mounts
CAD $375.00
Designed for mounting 1800cc Yamaha engines. These engine mounts are designed to work with common stringer interfaces on all Minijet A2 series hulls. This mount assembly replaces the oEM cast engine mounting brackets that are attached to the engine block, and they allow you to reuse the OEM rubber isolator mounts.
Please note, these mounts are provided as a tack-welded kit. They are pre-assembled in the correct orientation to work with most engines. You must confirm this orientation and complete the remaining welding work before installing these mounts.
Additional information
Related products
Bilge Hose (1-1/8in diameter, 6ft length)
This bilge hose is ideal for routing your bilge water out of your hull, and it is designed to work with our automatic bilge pump and hull bypass fittings.
Bilge hose has a 1-1/8in diameter and is sold in 6 foot lengths. Most boats use between 4ft and 6ft of hose. For custom length please contact us.
Traditional Sand Trap
Traditional style jetboat sand trap. Some users prefer this sand trap because it is less prone to clogging, however it does allow some particulate matter into the cooling loop.
Our Minijet Sand Trap Kit uses a filter element that is easily removeable for cleaning, and removes more particulate matter.
Minijet Yamaha RiDE Relocate Kit
Our Minijet Yamaha RiDE Relocate Kit allows you to maintain the OEM trim and reverse functions of the Yamaha RiDE system, while relocating the motor inboard on your boat.
Minijet Yamaha RiDE Relocate Kit Includes:
- motor and cable mounting plate
- QTY 2 6-foot trim and reverse cables
- QTY 2 trim and reverse cable ends
- QTY 2 trim and reverse cable extension kits
- QTY 2 4300 Series Cable Mounting Clamps
- QTY 2 4300 Series Cable Mounting Spacers
Heat Exchanger
Back in stock!
Heat exchanger for closed cooled Seadoo and small car motors. End caps are removable for easy winterizing and for cleaning out debris. Each end cap can be rotated and fastened in multiple orientations at 90 degree intervals to facilitate optimal hose management.
Glycol flows through 2 center fittings (1 inch hose size on Sea-Doo’s) Lakewater flows through two brass end caps (3/4 inch hose size on Sea-Doo’s)
Fittings included are: 2x 3/4 inch NPT to 1 inch barb 2x 3/4 inch NPT to 3/4 inch barb
Automatic Bilge Pump
Our fully automatic bilge pump features a built in water sensor that eliminates the need for a separate float switch and extra wiring. The pump also has built in programming that can turn off the pump when it pump is running but not pumping water to protect the pump, and batteries.
- Capacity: 1,100 GPH
- Volts: 12VDC
- Amperage: 3.8 amp draw at maximum flow
- sold with straight fitting adapters for 1" and 1-1/8" hose.
- sold with snap on strainer that allows for easy cleaning and mounting.
